This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
ht500-2:manual [2017/02/28 12:40] Simon Kühling image fix |
ht500-2:manual [2017/02/28 13:12] Simon Kühling [Functional principle] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== HT500.2 - Manual ====== | ====== HT500.2 - Manual ====== | ||
- | [{{:HT500-2_freigestellt.jpg?600|The Kühling&Kühling HT500.2 3D Printer}}] | + | [{{ht500-2_cover-image.png?600|The Kühling&Kühling HT500.2 3D Printer}}] |
====== General ====== | ====== General ====== | ||
Line 35: | Line 35: | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{type_plate_HT500-2.png?400|Type plate on the rear side.}}] | + | [{{nameplate-example.png?400|Type plate on the rear side.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> | ||
Line 245: | Line 245: | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{gui_v110_emergencystop.png?400|The emergency stop button in the top-right corner of the GUI will immediately stop all movement and set the 3D Printer in a safe state for troubleshooting.}}] | + | [{{gui_emergencystop.png?400|The emergency stop button in the top-right corner of the GUI will immediately stop all movement and set the 3D Printer in a safe state for troubleshooting.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> |