ht500:knowledge-base
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
ht500:knowledge-base [2016/03/22 08:59] Markus Bürgener [Dual extrusion] obsolete info removed |
ht500:knowledge-base [2016/03/24 10:26] Simon Kühling [Handling 3D files] fix typo |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| <WRAP clear/> | <WRAP clear/> | ||
| === Wiper check === | === Wiper check === | ||
| - | <WRAP group> | ||
| - | <WRAP half column> | ||
| - | As previously mentioned, the HT500 dual extruder function is exclusively designed for the use with a wiper. The //Wiper Upgrade Kit// is available for 3D printers purchased before July 2015. Hardware revisions later than Rev1.3.0 can be equipped on request with the wiper ex factory.\\ | ||
| - | |||
| - | The following assumes that the wiper has already been installed according to the assembly instructions provided at delivery. If otherwise, find the [[ht500:service-guide#wiper-assembly-and-installation|instructions]] here. | ||
| - | </WRAP> | ||
| - | |||
| - | <WRAP half column> | ||
| - | [{{:reprap-industrial-v1:wiper_upgrade.png?400|The Wiper Upgrade Kit provides the necessary hardware for successfully printing dual extruder print jobs.}}] | ||
| - | </WRAP> | ||
| - | </WRAP> | ||
| - | |||
| <WRAP group> | <WRAP group> | ||
| <WRAP half column> | <WRAP half column> | ||
| Line 382: | Line 370: | ||
| __Slic3r part info:__\\ (see [[http://manual.slic3r.org/advanced/repairing-models|Slic3r manual]] also)\\ | __Slic3r part info:__\\ (see [[http://manual.slic3r.org/advanced/repairing-models|Slic3r manual]] also)\\ | ||
| After opening a file in Slic3r, the info box in the bottom-right corner of the plater shows information on the model status. For a single, suitable part the info must look like:\\ | After opening a file in Slic3r, the info box in the bottom-right corner of the plater shows information on the model status. For a single, suitable part the info must look like:\\ | ||
| - | ''Factes: xxxxx (1 shells)''\\ | + | ''Facets: xxxxx (1 shells)''\\ |
| ''Manifold: Yes''\\ | ''Manifold: Yes''\\ | ||
ht500/knowledge-base.txt · Last modified: 2016/12/05 23:23 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
