ht500:knowledge-base
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
ht500:knowledge-base [2016/03/22 09:01] Markus Bürgener [Basic dual extruder settings] obsolete wiper upgrade purchase info removed |
ht500:knowledge-base [2016/05/20 12:56] Markus Bürgener [Increasing the minimum detail resolution of the Slic3r] moved here |
||
|---|---|---|---|
| Line 370: | Line 370: | ||
| __Slic3r part info:__\\ (see [[http://manual.slic3r.org/advanced/repairing-models|Slic3r manual]] also)\\ | __Slic3r part info:__\\ (see [[http://manual.slic3r.org/advanced/repairing-models|Slic3r manual]] also)\\ | ||
| After opening a file in Slic3r, the info box in the bottom-right corner of the plater shows information on the model status. For a single, suitable part the info must look like:\\ | After opening a file in Slic3r, the info box in the bottom-right corner of the plater shows information on the model status. For a single, suitable part the info must look like:\\ | ||
| - | ''Factes: xxxxx (1 shells)''\\ | + | ''Facets: xxxxx (1 shells)''\\ |
| ''Manifold: Yes''\\ | ''Manifold: Yes''\\ | ||
| Line 1401: | Line 1401: | ||
| |''M220 S<print speed multiplier in percent>'' | Increase/decrease print speed of all drive speeds | M220 S95\\ -> decrease print speed to 95 % of g-code value | | |''M220 S<print speed multiplier in percent>'' | Increase/decrease print speed of all drive speeds | M220 S95\\ -> decrease print speed to 95 % of g-code value | | ||
| + | ==== Increasing the minimum detail resolution of the Slic3r ==== | ||
| + | <WRAP group> | ||
| + | <WRAP half column> | ||
| + | - Open your Slic3r in "Expert" mode. | ||
| + | - Open the "Print Settings" tab. | ||
| + | - Choose "Advanced". | ||
| + | - Type the required resolution into the input field "Resolution" in the "Other" frame. We recommended setting the resolution to a value of ''0.05''. | ||
| + | <WRAP clear></WRAP> | ||
| + | </WRAP> | ||
| + | |||
| + | <WRAP half column> | ||
| + | [{{:reprap-industrial-v1:slic3r_minimumres.png?400|}}] | ||
| + | <WRAP info> | ||
| + | INFO | ||
| + | |||
| + | //Increasing the value can help solving the problem of blob formation. As a standard the value is set to "0" since it may cause problems with support structures.// | ||
| + | </WRAP> | ||
| + | </WRAP> | ||
| + | </WRAP> | ||
ht500/knowledge-base.txt · Last modified: 2016/12/05 23:23 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
