This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
ht500:knowledge-base [2016/03/24 10:26] Simon Kühling [Handling 3D files] fix typo |
ht500:knowledge-base [2016/05/20 12:56] Markus Bürgener [Increasing the minimum detail resolution of the Slic3r] moved here |
||
---|---|---|---|
Line 1401: | Line 1401: | ||
|''M220 S<print speed multiplier in percent>'' | Increase/decrease print speed of all drive speeds | M220 S95\\ -> decrease print speed to 95 % of g-code value | | |''M220 S<print speed multiplier in percent>'' | Increase/decrease print speed of all drive speeds | M220 S95\\ -> decrease print speed to 95 % of g-code value | | ||
+ | ==== Increasing the minimum detail resolution of the Slic3r ==== | ||
+ | <WRAP group> | ||
+ | <WRAP half column> | ||
+ | - Open your Slic3r in "Expert" mode. | ||
+ | - Open the "Print Settings" tab. | ||
+ | - Choose "Advanced". | ||
+ | - Type the required resolution into the input field "Resolution" in the "Other" frame. We recommended setting the resolution to a value of ''0.05''. | ||
+ | <WRAP clear></WRAP> | ||
+ | </WRAP> | ||
+ | |||
+ | <WRAP half column> | ||
+ | [{{:reprap-industrial-v1:slic3r_minimumres.png?400|}}] | ||
+ | <WRAP info> | ||
+ | INFO | ||
+ | |||
+ | //Increasing the value can help solving the problem of blob formation. As a standard the value is set to "0" since it may cause problems with support structures.// | ||
+ | </WRAP> | ||
+ | </WRAP> | ||
+ | </WRAP> |