User Tools

Site Tools


ht500:manual

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
ht500:manual [2016/07/08 08:03]
Simon Kühling [Warranty terms] Update to GmbH
ht500:manual [2018/06/11 14:23] (current)
Simon Kühling
Line 442: Line 442:
 <WRAP half column> <WRAP half column>
 The nozzle is [[service-guide#​changing-the-nozzle-tip|exchangeable]] to provide different bore diameters for different materials, layer thicknesses or print speed. Ex factory, the 0.35mm tip is preinstalled. Additionally,​ three nozzles with diameters of 0.25mm, 0.5mm and 0.75mm are included. The tips are distinguishable by the engraved markings.\\ \\ The nozzle is [[service-guide#​changing-the-nozzle-tip|exchangeable]] to provide different bore diameters for different materials, layer thicknesses or print speed. Ex factory, the 0.35mm tip is preinstalled. Additionally,​ three nozzles with diameters of 0.25mm, 0.5mm and 0.75mm are included. The tips are distinguishable by the engraved markings.\\ \\
-The 0.35mm and the 0.5mm nozzles should be used for most purposes and can be operated at an extrusion ​speed of up to\\ 60mm/s. The [[https://​github.com/​kuehlingkuehling/​RepRap-Industrial-Slic3r-profiles|Slic3r profiles]] provided by Kühling&​Kühling are optimized for the 0.35mm nozzle. Additional information can be found in the [[service-guide#​changing-the-nozzle-tip|Service Guide]] and in the [[http://​manual.slic3r.org/​|Slic3r manual]].\\ Please try and find the settings best suited for your task. The Slic3r profiles will be constantly updated and extended.\\ The 0.75mm nozzle is primarily intended for experimental usage and should only be used with a max. extrusion ​speed of 20mm/s for a start. Adjust the extrusion ​speed stepwise until optimized for your needs.\\ The 0.25mm nozzle is for filigree, thin walled extrusions. Do not exceed an extrusion ​speed of 35mm/s since the material throughput will not suffice for higher speeds.+The 0.35mm and the 0.5mm nozzles should be used for most purposes and can be operated at a print speed of up to\\ 60mm/s. The [[https://​github.com/​kuehlingkuehling/​RepRap-Industrial-Slic3r-profiles|Slic3r profiles]] provided by Kühling&​Kühling are optimized for the 0.35mm nozzle. Additional information can be found in the [[service-guide#​changing-the-nozzle-tip|Service Guide]] and in the [[http://​manual.slic3r.org/​|Slic3r manual]].\\ Please try and find the settings best suited for your task. The Slic3r profiles will be constantly updated and extended.\\ The 0.75mm nozzle is primarily intended for experimental usage and should only be used with a max. print speed of 20mm/s for a start. Adjust the print speed stepwise until optimized for your needs.\\ The 0.25mm nozzle is for filigree, thin walled extrusions. Do not exceed an print speed of 35mm/s since the material throughput will not suffice for higher speeds.
 </​WRAP>​ </​WRAP>​
  
ht500/manual.txt · Last modified: 2018/06/11 14:23 by Simon Kühling