This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
ht500:quick-start-guide [2016/03/18 15:17] Simon Kühling |
ht500:quick-start-guide [2016/03/23 11:06] Markus Bürgener very minor changes |
||
---|---|---|---|
Line 150: | Line 150: | ||
<WRAP half column> | <WRAP half column> | ||
* Switch to the **Setup** tab via the respective button in the header. | * Switch to the **Setup** tab via the respective button in the header. | ||
- | * Write down the web-interface URL displayed on the right half of the screen. | + | * Write down the web interface URL displayed on the right half of the screen. |
</WRAP> | </WRAP> | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{ :reprap-industrial-v1:qsg_setupurl_fullscreen.png?400 |The web-interface URL on the SETUP screen is required for connecting the 3D Printer with your local network.}}] | + | [{{ :reprap-industrial-v1:qsg_setupurl_fullscreen.png?400 |The web interface URL on the SETUP screen is required for connecting the 3D Printer with your local network.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> | ||
Line 160: | Line 160: | ||
<WRAP group> | <WRAP group> | ||
<WRAP half column> | <WRAP half column> | ||
- | * Now open your web browser on your PC and enter the web-interface URL in the address line and you will be greeted with the **First steps** screen that provides a direct link to the online manual.\\ \\ All further steps are explained in in the Initial Commissioning chapter of the operating manual under [[http://docs.kuehlingkuehling.de/ht500/operation#initial-commissioning]]\\ \\ If you encounter problems with accessing the 3D Printer (or anything else) you may find help in the Troubleshooting section of the online manual\\ ([[http://docs.kuehlingkuehling.de/ht500/troubleshooting]]). | + | * Now open your web browser on your PC and enter the web interface URL in the address line and you will be greeted with the **First steps** screen that provides a direct link to the online manual.\\ \\ All further steps are explained in in the Initial Commissioning chapter of the operating manual under [[http://docs.kuehlingkuehling.de/ht500/operation#initial-commissioning]]\\ \\ If you encounter problems with accessing the 3D Printer (or anything else) you may find help in the Troubleshooting section of the online manual\\ ([[http://docs.kuehlingkuehling.de/ht500/troubleshooting]]). |
</WRAP> | </WRAP> | ||