This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ht500:quick-start-guide [2016/03/23 11:10] Markus Bürgener very minor changes |
ht500:quick-start-guide [2016/03/24 11:41] (current) Markus Bürgener [Safety precautions] |
||
---|---|---|---|
Line 40: | Line 40: | ||
</WRAP> | </WRAP> | ||
+ | <WRAP pagebreak></WRAP> | ||
<WRAP group> | <WRAP group> | ||
Line 68: | Line 69: | ||
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> | ||
+ | |||
+ | <WRAP pagebreak></WRAP> | ||
===== Safety precautions ===== | ===== Safety precautions ===== | ||
Line 103: | Line 106: | ||
NOTICE | NOTICE | ||
- | In order to ensure your own safety and the proper functioning of your HT500 during operation read and observe the safety instructions in the online documentation. | + | If the 3D Printer has a temperature below 16°C (e.g. directly after delivery in cold weather) there is a danger of air humidity condensing on sensitive electronic components. This can lead to severe damages due to short circuiting during commissioning.\\ Therefore, it is necessary to thoroughly let the 3D Printer warm up to ambient temperature for at least 12 hrs. at its operating place **prior** to commissioning.\\ Regard the [[technical-data#td-ac|ambient conditions]] required for operation. |
</WRAP> | </WRAP> | ||
+ | <WRAP note> | ||
+ | NOTICE | ||
+ | |||
+ | In order to ensure your own safety and the proper functioning of your HT500 during operation read and observe the safety instructions in the online documentation. | ||
+ | </WRAP> | ||
===== Installation requirements ===== | ===== Installation requirements ===== | ||
<WRAP group> | <WRAP group> |