ht500:technical-data
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
ht500:technical-data [2016/07/07 10:18] Simon Kühling |
ht500:technical-data [2017/06/09 12:20] (current) Simon Kühling [Hardware revision v1.4.x] remove experimental materials |
||
|---|---|---|---|
| Line 36: | Line 36: | ||
| | Print bed | exchangeable 210x210mm PEI/glass fabric/carbon composite sheet | | | Print bed | exchangeable 210x210mm PEI/glass fabric/carbon composite sheet | | ||
| | Minimum layer resolution | 0.1mm | | | Minimum layer resolution | 0.1mm | | ||
| - | | Reproduction accuracy | ±0.2mm | | + | | Positioning accuracy | ±0.1mm | |
| - | | Tolerance | ±0.2mm | | + | | Approx. Tolerance | ±0.2mm | |
| === Material === | === Material === | ||
| |<75% 40% 60%>| | |<75% 40% 60%>| | ||
| - | | Printable materials | ABS, PLA, HIPS, PVA, PC, PA12, PET, PEEK, PP, POM | | + | | Printable materials | ABS, PLA, HIPS, PVA, PC, PA12, PET | |
| | Filament diameter | 2.85±0.1mm | | | Filament diameter | 2.85±0.1mm | | ||
| | Available filament qty. | 0.75kg spool (200x55mm)\\ 2.30kg spool (296x100mm) | | | Available filament qty. | 0.75kg spool (200x55mm)\\ 2.30kg spool (296x100mm) | | ||
ht500/technical-data.1467886710.txt.gz · Last modified: 2016/07/07 10:18 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
