reprap-industrial-v1:quick-start-guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
reprap-industrial-v1:quick-start-guide [2014/10/10 10:34] Markus Bürgener Adapted to new safety label design |
reprap-industrial-v1:quick-start-guide [2014/10/28 15:14] Markus Bürgener [Electrical safety] moist environment added |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| In order to ensure your own safety and the proper functioning of your RepRap Industrial read and observe the following information. | In order to ensure your own safety and the proper functioning of your RepRap Industrial read and observe the following information. | ||
| ==== Electrical safety ==== | ==== Electrical safety ==== | ||
| - | * Only connect the 3D Printer to the specified supply voltage. | + | * Only connect the 3D printer to the specified supply voltage. |
| - | * Do not operate the 3D Printer with defective cable connections. | + | * Do not operate the 3D printer with defective cable connections. |
| + | * Do not setup the 3D printer in a moist environment. | ||
| * Work on the electrical connections and the electrical equipment of the 3D Printer **must only** be carried out by trained personnel. | * Work on the electrical connections and the electrical equipment of the 3D Printer **must only** be carried out by trained personnel. | ||
| ==== Health hazards ==== | ==== Health hazards ==== | ||
| Line 67: | Line 68: | ||
| * Remove all remaining cardboard and blue tape used as transport protection from inside the build chamber. | * Remove all remaining cardboard and blue tape used as transport protection from inside the build chamber. | ||
| * Gently move the print head into the center of the build chamber by hand. | * Gently move the print head into the center of the build chamber by hand. | ||
| - | * Check the entire device carefully for any transportation damage. | + | * Check the entire device carefully for any transportation damage and completeness of delivery. |
| ===== Initial commissioning ===== | ===== Initial commissioning ===== | ||
reprap-industrial-v1/quick-start-guide.txt · Last modified: 2016/03/18 14:05 by Markus Bürgener
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
