reprap-industrial-v1:quick-start-guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
reprap-industrial-v1:quick-start-guide [2014/10/28 15:25] Markus Bürgener [Important Information on handling the print bed] |
reprap-industrial-v1:quick-start-guide [2014/12/04 09:43] Markus Bürgener [Initial commissioning] orthography |
||
|---|---|---|---|
| Line 103: | Line 103: | ||
| Adjusting the filament spools. | Adjusting the filament spools. | ||
| - | Depending on the diameter of the filament spool you install, you may have to adjust the spool guides in order to avoid poor conveyance of the filament.\\ The spool guides are preinstalled for fitting the 750 g spools provided for test reasons.\\ To adjust the spool guides: | + | Depending on the diameter of the filament spool you install, you may have to adjust the spool carrier in order to avoid poor conveyance of the filament.\\ The spool carriers are preinstalled for fitting the 750 g spools included in the delivery.\\ To adjust the spool carriers: |
| * Use an Allen wrench size 2.5 to //loosen// the two fixing screws of each spool guide. | * Use an Allen wrench size 2.5 to //loosen// the two fixing screws of each spool guide. | ||
| * Load a new filament spool onto the guide. Observe the direction of rotation. | * Load a new filament spool onto the guide. Observe the direction of rotation. | ||
reprap-industrial-v1/quick-start-guide.txt · Last modified: 2016/03/18 14:05 by Markus Bürgener
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
