vp75:initial-commissioning
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
vp75:initial-commissioning [2017/01/10 10:23] Simon Kühling [Removing objects from the build plate] wording |
vp75:initial-commissioning [2017/01/18 12:04] Simon Kühling [Extruder priming] wording |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| ===== Priming and preheating ===== | ===== Priming and preheating ===== | ||
| - | ==== Extruder priming ==== | + | ==== Print Head priming ==== |
| <WRAP group> | <WRAP group> | ||
| <WRAP half column> | <WRAP half column> | ||
| - | After material has been loaded the next step is priming the extruder to ensure good filling of the nozzle. | + | After material has been loaded the next step is priming the print head to ensure good filling of the nozzle. |
| * At the operating screen, open the //Expert Control// screen. | * At the operating screen, open the //Expert Control// screen. | ||
| * On the bottom side of the screen you will find buttons to heat the extruder. | * On the bottom side of the screen you will find buttons to heat the extruder. | ||
vp75/initial-commissioning.txt · Last modified: 2017/01/18 12:21 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
