vp75:safety
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
vp75:safety [2016/12/05 20:23] Markus Bürgener [Extruder nozzles] |
vp75:safety [2017/01/10 10:54] Simon Kühling [Electrical safety] |
||
|---|---|---|---|
| Line 53: | Line 53: | ||
| ==== Electrical safety ==== | ==== Electrical safety ==== | ||
| - | The supply voltage of the VP75 is 230 V(DC). It is reduced and distributed to 12 V and 5 V operating voltages by the power supply unit.\\ | + | The supply voltage of the VP75 is 230 V(DC). It is partially reduced and distributed to 24 V and 12 V operating voltages by the power supply unit.\\ |
| - | All current carrying parts are adequately isolated and encapsuled in the electronic compartment in the upper service chamber of the machine.\\ | + | All current carrying parts are adequately isolated and encapsuled in the electronic compartments in the upper and lower service chamber of the machine.\\ |
| To switch of current during normal operation, the machine is equipped with a main switch on the rear side. | To switch of current during normal operation, the machine is equipped with a main switch on the rear side. | ||
vp75/safety.txt · Last modified: 2017/03/14 14:25 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
