ht500-2:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
ht500-2:manual [2017/02/28 13:03] Simon Kühling [Hardware revisions] image fix |
ht500-2:manual [2017/02/28 13:12] Simon Kühling [Functional principle] |
||
|---|---|---|---|
| Line 245: | Line 245: | ||
| <WRAP half column> | <WRAP half column> | ||
| - | [{{gui_v110_emergencystop.png?400|The emergency stop button in the top-right corner of the GUI will immediately stop all movement and set the 3D Printer in a safe state for troubleshooting.}}] | + | [{{gui_emergencystop.png?400|The emergency stop button in the top-right corner of the GUI will immediately stop all movement and set the 3D Printer in a safe state for troubleshooting.}}] |
| </WRAP> | </WRAP> | ||
| </WRAP> | </WRAP> | ||
ht500-2/manual.txt · Last modified: 2017/02/28 13:51 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
