ht500:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
ht500:manual [2016/04/15 14:38] Markus Bürgener [Injury risks] |
ht500:manual [2016/05/25 07:09] Markus Bürgener [Hardware revisions] graphic changed |
||
|---|---|---|---|
| Line 35: | Line 35: | ||
| <WRAP half column> | <WRAP half column> | ||
| - | [{{:reprap-industrial-v1:typeplate_122015.png?400|Type plate on the rear side.}}] | + | [{{:ht500:type_plate_ht500.png?400|Type plate on the rear side.}}] |
| </WRAP> | </WRAP> | ||
| </WRAP> | </WRAP> | ||
| Line 160: | Line 160: | ||
| </WRAP> | </WRAP> | ||
| </WRAP> | </WRAP> | ||
| - | |||
| - | |||
| - | ===== EU declaration of conformity ===== | ||
| - | Valid {{:reprap-industrial-v1:ec-declaration-of-conformity.pdf|EU declaration of conformity}} for reference. | ||
| ===== Personnel safety and device reliability ===== | ===== Personnel safety and device reliability ===== | ||
| Line 226: | Line 222: | ||
| === Noise === | === Noise === | ||
| - | The HT500 3D Printer is build to be operated in a professional environment such as workshops and laboratories. It is not suited for the operation in an office. The noise level may shortly reach peak values up to 73dB(A). During print jobs, it does not exceed 60dB(A), which is considered "unauspicious" for long-term exposure.\\ | + | The HT500 3D Printer is build to be operated in a professional environment such as workshops and laboratories. It is not suited for the operation in an office. During print jobs, it does not exceed 60dB(A), which is considered "unauspicious" for long-term exposure.\\ |
| Special noise protection equipment is not required. | Special noise protection equipment is not required. | ||
| Line 568: | Line 564: | ||
| <WRAP half column> | <WRAP half column> | ||
| - | [{{:reprap-industrial-v1:desc_filamentfeedunit.png?400|Filament supply}}] | + | [{{:ht500:desc_filamentfeedunit.png?400|Filament supply}}] |
| - | [{{:reprap-industrial-v1:desc_filamentfeedunit_dustsponge.png?400|Filament inlet with limit switch and dust wiping sponge.}}] | + | [{{:ht500:desc_filamentfeedunit_dustsponge.png?400|Filament inlet with limit switch and dust wiping sponge.}}] |
| </WRAP> | </WRAP> | ||
| </WRAP> | </WRAP> | ||
ht500/manual.txt · Last modified: 2018/06/11 14:23 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
