This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
ht500:manual [2016/04/25 13:30] Simon Kühling removed outdated paragraph |
ht500:manual [2016/05/12 11:20] Markus Bürgener [Filament supply] graphic quality improved |
||
---|---|---|---|
Line 222: | Line 222: | ||
=== Noise === | === Noise === | ||
- | The HT500 3D Printer is build to be operated in a professional environment such as workshops and laboratories. It is not suited for the operation in an office. The noise level may shortly reach peak values up to 73dB(A). During print jobs, it does not exceed 60dB(A), which is considered "unauspicious" for long-term exposure.\\ | + | The HT500 3D Printer is build to be operated in a professional environment such as workshops and laboratories. It is not suited for the operation in an office. During print jobs, it does not exceed 60dB(A), which is considered "unauspicious" for long-term exposure.\\ |
Special noise protection equipment is not required. | Special noise protection equipment is not required. | ||
Line 564: | Line 564: | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{:reprap-industrial-v1:desc_filamentfeedunit.png?400|Filament supply}}] | + | [{{:ht500:desc_filamentfeedunit.png?400|Filament supply}}] |
- | [{{:reprap-industrial-v1:desc_filamentfeedunit_dustsponge.png?400|Filament inlet with limit switch and dust wiping sponge.}}] | + | [{{:ht500:desc_filamentfeedunit_dustsponge.png?400|Filament inlet with limit switch and dust wiping sponge.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> |