This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
ht500:manual [2016/04/26 14:34] Markus Bürgener [Injury risks] "Noise" specified |
ht500:manual [2016/05/25 08:16] Markus Bürgener [Hardware components] new graphic and structure |
||
---|---|---|---|
Line 35: | Line 35: | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{:reprap-industrial-v1:typeplate_122015.png?400|Type plate on the rear side.}}] | + | [{{:ht500:type_plate_ht500.png?400|Type plate on the rear side.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> | ||
Line 320: | Line 320: | ||
| **R** | Right | Right side of the 3D Printer, referred to the frontal view. | | | **R** | Right | Right side of the 3D Printer, referred to the frontal view. | | ||
| **B** | Back | Backside of the 3D Printer, referred to the frontal view | | | **B** | Back | Backside of the 3D Printer, referred to the frontal view | | ||
- | </WRAP> | ||
- | <WRAP half column> | ||
- | [{{:reprap-industrial-v1:desc_points_of_view.png?400|Directions and aspects of the 3D Printer. All statements refer to the frontal view.}}] | ||
- | </WRAP> | ||
- | </WRAP> | ||
- | |||
- | |||
- | <WRAP group> | ||
- | <WRAP half column> | ||
All movement directions of the axes are defined throughout this manual as follows: | All movement directions of the axes are defined throughout this manual as follows: | ||
|<100% 5% 25% 70%>| | |<100% 5% 25% 70%>| | ||
Line 339: | Line 330: | ||
| **Z⊕** | Z positive | Print table moves down. | | | **Z⊕** | Z positive | Print table moves down. | | ||
| **ZΘ** | Z negative | Print table moves up. | | | **ZΘ** | Z negative | Print table moves up. | | ||
+ | |||
+ | |||
+ | |||
</WRAP> | </WRAP> | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{:reprap-industrial-v1:desc_moving_axes.png?400|Denotation and direction determination of the axes.}}] | + | [{{:ht500:directions_ht500.png?400|Directions and aspects of the 3D Printer. All statements refer to the frontal view.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> | ||
- | |||
<WRAP group> | <WRAP group> | ||
Line 564: | Line 557: | ||
<WRAP half column> | <WRAP half column> | ||
- | [{{:reprap-industrial-v1:desc_filamentfeedunit.png?400|Filament supply}}] | + | [{{:ht500:desc_filamentfeedunit.png?400|Filament supply}}] |
- | [{{:reprap-industrial-v1:desc_filamentfeedunit_dustsponge.png?400|Filament inlet with limit switch and dust wiping sponge.}}] | + | [{{:ht500:desc_filamentfeedunit_dustsponge.png?400|Filament inlet with limit switch and dust wiping sponge.}}] |
</WRAP> | </WRAP> | ||
</WRAP> | </WRAP> |