ht500:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
ht500:manual [2016/07/08 07:55] Simon Kühling [Imprint] Updated to GmbH |
ht500:manual [2016/07/08 07:58] Simon Kühling [General] Update du GmbH |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== General ====== | ====== General ====== | ||
| - | Welcome to the HT500 3D Printer operating manual of the Jonas Kühling & Simon Kühling GbR (in the following referred to as //Kühling&Kühling//).\\ | + | Welcome to the HT500 3D Printer operating manual of the Kühling&Kühling GmbH (in the following referred to as //Kühling&Kühling//).\\ |
| The HT500 3D Printer (in the following referred to as //HT500// or //3D Printer//) is a fully automatic stand-alone device for **F**used-**F**ilament-**F**abrication (FFF) in a lab or commercial environment.\\ Any information needed for [[#setup-and-installation|installing and commissioning]], [[#touchscreen-operation|operating]], [[#troubleshooting|]], [[service-guide|maintenance and repair]] of the 3D Printer are described in the following paragraphs and the accompanying sites.\\ | The HT500 3D Printer (in the following referred to as //HT500// or //3D Printer//) is a fully automatic stand-alone device for **F**used-**F**ilament-**F**abrication (FFF) in a lab or commercial environment.\\ Any information needed for [[#setup-and-installation|installing and commissioning]], [[#touchscreen-operation|operating]], [[#troubleshooting|]], [[service-guide|maintenance and repair]] of the 3D Printer are described in the following paragraphs and the accompanying sites.\\ | ||
| This user's manual must be read thoroughly as it is meant to provide the operator with all information needed to operate the HT500 safely and reasonably. Please always provide access to the website for any user of the 3D Printer in case of questions or problems. | This user's manual must be read thoroughly as it is meant to provide the operator with all information needed to operate the HT500 safely and reasonably. Please always provide access to the website for any user of the 3D Printer in case of questions or problems. | ||
ht500/manual.txt · Last modified: 2018/06/11 14:23 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
