ht500:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
ht500:manual [2016/07/08 07:55] Simon Kühling [Imprint] Updated to GmbH |
ht500:manual [2016/07/08 08:03] Simon Kühling [Warranty terms] Update to GmbH |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== General ====== | ====== General ====== | ||
| - | Welcome to the HT500 3D Printer operating manual of the Jonas Kühling & Simon Kühling GbR (in the following referred to as //Kühling&Kühling//).\\ | + | Welcome to the HT500 3D Printer operating manual of the Kühling&Kühling GmbH (in the following referred to as //Kühling&Kühling//).\\ |
| The HT500 3D Printer (in the following referred to as //HT500// or //3D Printer//) is a fully automatic stand-alone device for **F**used-**F**ilament-**F**abrication (FFF) in a lab or commercial environment.\\ Any information needed for [[#setup-and-installation|installing and commissioning]], [[#touchscreen-operation|operating]], [[#troubleshooting|]], [[service-guide|maintenance and repair]] of the 3D Printer are described in the following paragraphs and the accompanying sites.\\ | The HT500 3D Printer (in the following referred to as //HT500// or //3D Printer//) is a fully automatic stand-alone device for **F**used-**F**ilament-**F**abrication (FFF) in a lab or commercial environment.\\ Any information needed for [[#setup-and-installation|installing and commissioning]], [[#touchscreen-operation|operating]], [[#troubleshooting|]], [[service-guide|maintenance and repair]] of the 3D Printer are described in the following paragraphs and the accompanying sites.\\ | ||
| This user's manual must be read thoroughly as it is meant to provide the operator with all information needed to operate the HT500 safely and reasonably. Please always provide access to the website for any user of the 3D Printer in case of questions or problems. | This user's manual must be read thoroughly as it is meant to provide the operator with all information needed to operate the HT500 safely and reasonably. Please always provide access to the website for any user of the 3D Printer in case of questions or problems. | ||
| Line 64: | Line 64: | ||
| ===== Warranty terms ===== | ===== Warranty terms ===== | ||
| - | The general [[http://www.kuehlingkuehling.de/terms/|terms and conditions]] of Jonas Kühling & Simon Kühling GbR apply. The customer is familiar with these terms latest on the day of signing the purchase contract. | + | The general [[http://www.kuehlingkuehling.de/terms/|terms and conditions]] of Kühling&Kühling GmbH apply. The customer is familiar with these terms latest on the day of signing the purchase contract. |
| The warranty terms and the liability period can be found in the contract documents and in the order confirmation. | The warranty terms and the liability period can be found in the contract documents and in the order confirmation. | ||
ht500/manual.txt · Last modified: 2018/06/11 14:23 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
