ht500:quick-start-guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
ht500:quick-start-guide [2016/03/23 13:25] Markus Bürgener |
ht500:quick-start-guide [2016/03/24 10:54] Markus Bürgener [Safety precautions] Note about ambient conditions added |
||
|---|---|---|---|
| Line 104: | Line 104: | ||
| <WRAP note> | <WRAP note> | ||
| - | NOTICE | + | NOTE |
| - | In order to ensure your own safety and the proper functioning of your HT500 during operation read and observe the safety instructions in the online documentation. | + | If the 3D Printer has a temperature below 16°C (e.g. directly after delivery in cold weather) there is a danger of air humidity condensing on sensitive electronic components. This can lead to severe damages due to short circuiting during commissioning.\\ Therefore, it is necessary to thoroughly let the 3D Printer warm up to ambient temperature for at least 12 hrs. at its operating place **prior** to commissioning.\\ Regard the [[technical-data#td-ac|ambient conditions]] required for operation. |
| </WRAP> | </WRAP> | ||
| - | <WRAP pagebreak></WRAP> | + | <WRAP note> |
| + | NOTICE | ||
| + | In order to ensure your own safety and the proper functioning of your HT500 during operation read and observe the safety instructions in the online documentation. | ||
| + | </WRAP> | ||
| ===== Installation requirements ===== | ===== Installation requirements ===== | ||
| <WRAP group> | <WRAP group> | ||
ht500/quick-start-guide.txt · Last modified: 2016/03/24 11:41 by Markus Bürgener
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
