reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning [2014/12/03 15:11] Markus Bürgener extruder calibration added |
reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning [2014/12/18 11:52] Markus Bürgener [Extruder calibration] |
||
|---|---|---|---|
| Line 395: | Line 395: | ||
| //When printing ABS it __may be__ necessary to run the [Extrusion calibration] wizard after changing the filament spool without changing the material itself.\\ | //When printing ABS it __may be__ necessary to run the [Extrusion calibration] wizard after changing the filament spool without changing the material itself.\\ | ||
| - | It __is__ necessary to find the correct extrusion multiplier after changing the material. The respective procedure is described [[tips-tricks#Finding the extrusion multiplier for new materials|here]].// | + | It __is__ necessary to find the correct extrusion multiplier after changing the material. The respective procedure is described [[tips-tricks#calibrating-the-extrusion|here]].// |
| </WRAP> | </WRAP> | ||
| </WRAP> | </WRAP> | ||
reprap-industrial-v1/software-version-v1.0.5-operation-and-commissioning.txt · Last modified: 2015/03/13 10:06 by Markus Bürgener
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
