reprap-industrial-v1:tips-tricks
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
reprap-industrial-v1:tips-tricks [2015/05/28 08:48] Markus Bürgener [Easy evaluation of .stl-data] added |
reprap-industrial-v1:tips-tricks [2015/09/17 08:29] Markus Bürgener [Adjusting the build chamber temperature] |
||
|---|---|---|---|
| Line 85: | Line 85: | ||
| - | ===== Slicing ===== | + | ===== Handling 3D files ===== |
| Any information we gather related to improving or easing the slicing process is listed in the following paragraphs. | Any information we gather related to improving or easing the slicing process is listed in the following paragraphs. | ||
| Line 380: | Line 380: | ||
| software may differ in denotations): | software may differ in denotations): | ||
| - Open your slicing software. | - Open your slicing software. | ||
| - | - Open the tab "Printer Settings" and choose "Custom G-code". | + | - Open the tab [Printer Settings]. |
| - | -- Go to the line reading:\\ <code> M104 S70 T2; set recirculating air heater to 70 degree celcius target temperature</code> | + | - Choose the //Start G-code// in the "Custom G-code" menu. |
| - | - Change the entry "S//xy//" (here //S70//) by replacing the value //xy// with the desired temperature, for example //50° C//:\\ <code>M104 S50 T2; set recirculating air heater to 50 degree celcius target temperature</code> (for logical reasons, the comment should be aligned) | + | -- Scroll down to\\ ''; PREHEAT BED AND CHAMBER''\\ and position the cursor in the line reading:\\ <code> M104 S70 T2; set recirculating air heater to 70 degree celcius target temperature</code> |
| - | - If you want to keep the settings, save them in the profile (see [[http://manual.slic3r.org/|Slic3r manual]]). | + | - Change the entry "S//xy//" (here //S70//) by replacing the value //xy// with the desired temperature, for example //50° C//:\\ <code>M104 S50 T2; set recirculating air heater to 50 degree celcius target temperature</code> (for logical reasons, the comment should be aligned). |
| + | - If you want to keep the settings, save them in a new profile (see [[http://manual.slic3r.org/|Slic3r manual]]). | ||
| Any G-code exported with this profile loaded will heat the build chamber to the stated temperature prior to printing. | Any G-code exported with this profile loaded will heat the build chamber to the stated temperature prior to printing. | ||
| </WRAP> | </WRAP> | ||
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
