reprap-industrial-v1:tips-tricks
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
reprap-industrial-v1:tips-tricks [2015/09/17 08:29] Markus Bürgener [Adjusting the build chamber temperature] |
reprap-industrial-v1:tips-tricks [2015/09/17 08:45] Markus Bürgener [Deactivating the heating elements after end of print job] |
||
|---|---|---|---|
| Line 353: | Line 353: | ||
| <WRAP group> | <WRAP group> | ||
| <WRAP half column> | <WRAP half column> | ||
| - | * Open the [Printer Settings] tab in Slic3r and choose the //Custom G-code// menu. | + | - Start your slicing software. |
| - | * Activate the End G-code editor by clicking into the text field. | + | - Open the [Printer Settings] tab. |
| - | * Position the cursor in the last line before the ''; /END-GCODE'' entry. | + | - Choose the "Custom G-code" menu. |
| - | * Enter the command\\ ''M104 S0 T2''\\ This will set the heating elements of the build chamber to a temperature of 0 °C. | + | - In the //End G-Code// editor scroll down to the end of the text field and position the cursor in the last line above the ''; /END-GCODE'' entry. |
| - | * Enter the command\\ ''M140 S0''\\ This will deactivate the print bed as the last action of the current G-code. | + | - Enter the command\\ ''M104 S0 T2''\\ This will set the heating elements of the build chamber to a temperature of 0 °C. |
| + | - Enter the command\\ ''M140 S0''\\ This will deactivate the print bed as the last action of the current G-code. | ||
| </WRAP> | </WRAP> | ||
| <WRAP half column> | <WRAP half column> | ||
| - | [{{:reprap-industrial-v1:slic3r_endgcode.png?400|Switching off the build chamber heating elements by modifying the Slic3r custom End G-code.}}] | + | [{{:reprap-industrial-v1:tt_slic3r_modify_endgcode_autooff.png?400|Switching off the build chamber heating elements by modifying the Slic3r custom End G-code.}}] |
| </WRAP> | </WRAP> | ||
| </WRAP> | </WRAP> | ||
| Line 380: | Line 381: | ||
| software may differ in denotations): | software may differ in denotations): | ||
| - Open your slicing software. | - Open your slicing software. | ||
| - | - Open the tab "Printer Settings". | + | - Open the tab [Printer Settings]. |
| - Choose the //Start G-code// in the "Custom G-code" menu. | - Choose the //Start G-code// in the "Custom G-code" menu. | ||
| -- Scroll down to\\ ''; PREHEAT BED AND CHAMBER''\\ and position the cursor in the line reading:\\ <code> M104 S70 T2; set recirculating air heater to 70 degree celcius target temperature</code> | -- Scroll down to\\ ''; PREHEAT BED AND CHAMBER''\\ and position the cursor in the line reading:\\ <code> M104 S70 T2; set recirculating air heater to 70 degree celcius target temperature</code> | ||
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
