vp75:safety
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
vp75:safety [2016/12/05 20:18] Markus Bürgener [Product reliability] |
vp75:safety [2016/12/05 20:23] Markus Bürgener [Extruder nozzles] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| </WRAP> | </WRAP> | ||
| - | Nonetheless, hazardous situations may appear due to the production process itself and property damage may be caused by false operation.\\ \\ | + | Nonetheless, hazardous situations may appear due to the production process itself.\\ False operation and/or handling of components can lead to intensive property damage; therefore we strongly recommend following the information given in this manual.\\ \\ |
| **The risk of experiencing hazardous situations is increased by:** | **The risk of experiencing hazardous situations is increased by:** | ||
| * Using the VP75 for other applications than the intended. | * Using the VP75 for other applications than the intended. | ||
| Line 108: | Line 108: | ||
| During normal operation it is not necessary to wear special protective gear. Some tasks however should not be performed without taking protective measures. Situations that require protective equipment are specially indicated. It is the owner's obligation to provide adequate protective equipment. | During normal operation it is not necessary to wear special protective gear. Some tasks however should not be performed without taking protective measures. Situations that require protective equipment are specially indicated. It is the owner's obligation to provide adequate protective equipment. | ||
| - | ===== Product reliability ===== | ||
| - | False handling of components can lead to loss of production due to property damage; therefore we strongly recommend following the information given in this manual. | ||
| - | ===== Extruder nozzles ===== | ||
| - | The extruder nozzle is sensitive to heat treatment and mechanical strain.\\ If the nozzle or extruder barrel are clogged by congealed material, reheating during the normal production flow is utterly sufficient to clear them in most cases.\\ In case you want to change the material type or clogging is effected by foreign particles (i.e. dust grains dragged along with the filament), it is necessary to remove congealed material from the nozzle. The corresponding description can be found in the [[#Cleaning recommendation|cleaning recommendation]]. | ||
| - | <WRAP clear></WRAP> | ||
| - | <WRAP note> | ||
| - | NOTICE | ||
| - | |||
| - | //Do not use mechanical tools or open flames to remelt or remove residues in the nozzle. Overheating may induce easing of tensions and deformation. The nozzle is then no longer usable for production.// | ||
| - | </WRAP> | ||
vp75/safety.txt · Last modified: 2017/03/14 14:25 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
