This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ht500:service-guide [2016/05/20 12:23] Markus Bürgener [Changing the hot-end barrels] false pictures removed, adapted to ht500 |
ht500:service-guide [2017/01/18 09:51] (current) Simon Kühling old revision restored (2016/05/20 12:55) |
||
---|---|---|---|
Line 898: | Line 898: | ||
- | ==== Increasing the minimum detail resolution of the Slic3r ==== | ||
- | <WRAP group> | ||
- | <WRAP half column> | ||
- | - Open your Slic3r in "Expert" mode. | ||
- | - Open the "Print Settings" tab. | ||
- | - Choose "Advanced". | ||
- | - Type the required resolution into the input field "Resolution" in the "Other" frame. We recommended setting the resolution to a value of ''0.05''. | ||
- | <WRAP clear></WRAP> | ||
- | </WRAP> | ||
- | <WRAP half column> | ||
- | [{{:reprap-industrial-v1:slic3r_minimumres.png?400|}}] | ||
- | <WRAP info> | ||
- | INFO | ||
- | |||
- | //Increasing the value can help solving the problem of blob formation. As a standard the value is set to "0" since it may cause problems with support structures.// | ||
- | </WRAP> | ||
- | </WRAP> | ||
- | </WRAP> |