Differences

This shows you the differences between two versions of the page.

--- reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning [2014/11/03 14:44]
Markus Bürgener [Initial commissioning] links updated
+++ reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning [2014/11/03 15:05]
Markus Bürgener [Initial commissioning]
@@ Line 314: / Line 314: @@
 ===== Initial commissioning =====
-After [[:reprap-industrial-v1:manual|installation]] the RepRap Industrial is ready for initial commissioning. The first few steps will prepare your RepRap Industrial for its day-to-day duty:
+After [[manual#Setup and Installation|installation]] the RepRap Industrial is ready for initial commissioning. The first few steps will prepare your RepRap Industrial for its day-to-day duty:
   * Make sure that no foreign objects are left in the build chamber (transport locks, tools or the like).
   * Close the build chamber.
@@ Line 351: / Line 351: @@
 To check or alter the settings, proceed as follows:
-The material profile for each extruder is chosen via the [Select Filament Profile] button in the **//Setup//** menu.
+The material profile for each extruder is chosen via the [Select Filament Profile] button in the //Setup// menu.
 </WRAP>
@@ Line 458: / Line 458: @@
 <WRAP group>
 <WRAP half column>
-Make sure that all steps described in //[[#First start-up]]// have been carried out.
+Make sure that all previously described steps have been carried out.
 The next steps are carried out at the 3D printer's GUI:\\