reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning [2014/11/03 15:03] Markus Bürgener [Initial commissioning] links updated |
reprap-industrial-v1:software-version-v1.0.5-operation-and-commissioning [2014/11/03 15:04] Markus Bürgener [The first print] links updated/deleted |
||
|---|---|---|---|
| Line 458: | Line 458: | ||
| <WRAP group> | <WRAP group> | ||
| <WRAP half column> | <WRAP half column> | ||
| - | Make sure that all steps described in //[[#First start-up]]// have been carried out. | + | Make sure that all previously described steps have been carried out. |
| The next steps are carried out at the 3D printer's GUI:\\ | The next steps are carried out at the 3D printer's GUI:\\ | ||
reprap-industrial-v1/software-version-v1.0.5-operation-and-commissioning.txt · Last modified: 2015/03/13 10:06 by Markus Bürgener
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
