ht500:knowledge-base
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
ht500:knowledge-base [2016/03/24 10:26] Simon Kühling [Handling 3D files] fix typo |
ht500:knowledge-base [2016/06/28 10:13] Simon Kühling Fix video link |
||
|---|---|---|---|
| Line 1295: | Line 1295: | ||
| * Before waisting time on unsuccessful leveling, please rethink if the currently installed nozzle tip is adequate for the print job. Wider nozzles are more tolerant when it comes to compensating leveling mistakes and may be more suited to the task, especially when printing larger parts. | * Before waisting time on unsuccessful leveling, please rethink if the currently installed nozzle tip is adequate for the print job. Wider nozzles are more tolerant when it comes to compensating leveling mistakes and may be more suited to the task, especially when printing larger parts. | ||
| </WRAP> | </WRAP> | ||
| + | |||
| <WRAP half column> | <WRAP half column> | ||
| {{:ht500:leveling_ok.mp4?400|Leveling test is OK}} | {{:ht500:leveling_ok.mp4?400|Leveling test is OK}} | ||
| Line 1401: | Line 1401: | ||
| |''M220 S<print speed multiplier in percent>'' | Increase/decrease print speed of all drive speeds | M220 S95\\ -> decrease print speed to 95 % of g-code value | | |''M220 S<print speed multiplier in percent>'' | Increase/decrease print speed of all drive speeds | M220 S95\\ -> decrease print speed to 95 % of g-code value | | ||
| + | ==== Increasing the minimum detail resolution of the Slic3r ==== | ||
| + | <WRAP group> | ||
| + | <WRAP half column> | ||
| + | - Open your Slic3r in "Expert" mode. | ||
| + | - Open the "Print Settings" tab. | ||
| + | - Choose "Advanced". | ||
| + | - Type the required resolution into the input field "Resolution" in the "Other" frame. We recommended setting the resolution to a value of ''0.05''. | ||
| + | <WRAP clear></WRAP> | ||
| + | </WRAP> | ||
| + | |||
| + | <WRAP half column> | ||
| + | [{{:reprap-industrial-v1:slic3r_minimumres.png?400|}}] | ||
| + | <WRAP info> | ||
| + | INFO | ||
| + | |||
| + | //Increasing the value can help solving the problem of blob formation. As a standard the value is set to "0" since it may cause problems with support structures.// | ||
| + | </WRAP> | ||
| + | </WRAP> | ||
| + | </WRAP> | ||
ht500/knowledge-base.txt · Last modified: 2016/12/05 23:23 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
