ht500:service-guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
ht500:service-guide [2016/05/20 12:23] Markus Bürgener [Changing the hot-end barrels] false pictures removed, adapted to ht500 |
ht500:service-guide [2016/05/20 12:55] Markus Bürgener [Increasing the minimum detail resolution of the Slic3r] |
||
|---|---|---|---|
| Line 898: | Line 898: | ||
| - | ==== Increasing the minimum detail resolution of the Slic3r ==== | ||
| - | <WRAP group> | ||
| - | <WRAP half column> | ||
| - | - Open your Slic3r in "Expert" mode. | ||
| - | - Open the "Print Settings" tab. | ||
| - | - Choose "Advanced". | ||
| - | - Type the required resolution into the input field "Resolution" in the "Other" frame. We recommended setting the resolution to a value of ''0.05''. | ||
| - | <WRAP clear></WRAP> | ||
| - | </WRAP> | ||
| - | <WRAP half column> | ||
| - | [{{:reprap-industrial-v1:slic3r_minimumres.png?400|}}] | ||
| - | <WRAP info> | ||
| - | INFO | ||
| - | |||
| - | //Increasing the value can help solving the problem of blob formation. As a standard the value is set to "0" since it may cause problems with support structures.// | ||
| - | </WRAP> | ||
| - | </WRAP> | ||
| - | </WRAP> | ||
ht500/service-guide.txt · Last modified: 2017/01/18 09:51 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
