reprap-industrial-v1:manual
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
reprap-industrial-v1:manual [2015/12/11 08:39] Markus Bürgener [Electronic chamber] links updated |
reprap-industrial-v1:manual [2016/01/22 09:44] Markus Bürgener [Unpacking the machine] |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| ===== Valid Version ===== | ===== Valid Version ===== | ||
| + | ==== Hardware revisions ==== | ||
| <WRAP group> | <WRAP group> | ||
| <WRAP half column> | <WRAP half column> | ||
| Line 31: | Line 32: | ||
| * Serial number | * Serial number | ||
| * Date of manufacturing | * Date of manufacturing | ||
| - | * Hardware Revision | + | * Hardware Revision¹ |
| - | Starting with version **1.1.0** of the [[software-version-v1.1.0-operation-and-commissioning| operating software RepRapOnRails]] you will also find the valid hardware revision in the [[software-version-v1.1.0-operation-and-commissioning#setup-menue|[Setup] ]] menu on the touchscreen.\\ | + | ¹<wrap lo> Starting with version **1.1.0** of the [[software-version-v1.1.0-operation-and-commissioning| operating software RepRapOnRails]] you will also find the valid hardware revision in the [[software-version-v1.1.0-operation-and-commissioning#setup-menue|[Setup] ]] menu on the touchscreen.</wrap> |
| </WRAP> | </WRAP> | ||
| Line 737: | Line 738: | ||
| The transport box is made of unfinished plywood and may hold splinters and sharp edges that can cause cutting injuries. | The transport box is made of unfinished plywood and may hold splinters and sharp edges that can cause cutting injuries. | ||
| * Take care when removing the transport packaging and wear protective gloves. | * Take care when removing the transport packaging and wear protective gloves. | ||
| + | </WRAP> | ||
| + | |||
| + | <WRAP note> | ||
| + | NOTE | ||
| + | |||
| + | At ambient temperatures below 16°C air humidity may condensate inside the electronic chamber when the 3D Printer is warmed too quickly.\\ To avoid damages to the electronic components due to condensated water, set up the 3D Printer at its operating place and wait at least 24 hours prior to commissioning so that any moisture may evaporate.\\ Regard the [[technical-data#td-ac|ambient conditions]] required for operation. | ||
| </WRAP> | </WRAP> | ||
reprap-industrial-v1/manual.txt · Last modified: 2016/07/08 08:02 by Simon Kühling
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
