reprap-industrial-v1:quick-start-guide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
reprap-industrial-v1:quick-start-guide [2016/02/08 12:51] Markus Bürgener |
reprap-industrial-v1:quick-start-guide [2016/03/18 14:05] (current) Markus Bürgener [Connecting, turning on and accessing the 3D Printer] |
||
|---|---|---|---|
| Line 102: | Line 102: | ||
| NOTE | NOTE | ||
| - | If the 3D Printer has a temperature below 16°C (e.g. directly after delivery in cold weather) there is a danger of air humidity condensing on sensitive electronic components. This can lead to severe damages due to short circuiting during commissioning.\\ Therefore, it is necessary to let the 3D Printer warm up to ambient temperature at its operating place prior to commissioning.\\ Regard the [[technical-data#td-ac|ambient conditions]] required for operation. | + | If the 3D Printer has a temperature below 16°C (e.g. directly after delivery in cold weather) there is a danger of air humidity condensing on sensitive electronic components. This can lead to severe damages due to short circuiting during commissioning.\\ Therefore, it is necessary to let the 3D Printer warm up to ambient temperature at its operating place prior to commissioning.\\ Regard the ambient conditions (see Technical Data) required for operation. |
| </WRAP> | </WRAP> | ||
| Line 165: | Line 165: | ||
| <WRAP group> | <WRAP group> | ||
| <WRAP half column> | <WRAP half column> | ||
| - | * Now open your web browser on your PC and enter the web-interface URL in the address line. You will be greeted with the **First steps** screen that provides a direct link to the online manual where all steps next to be taken are explained in detail.\\ \\ If you encounter problems with accessing the 3D Printer (or anything else) you may find help in the Troubleshooting section of the online manual\\ ([[http://docs.kuehlingkuehling.de/reprap-industrial-v1/troubleshooting]]). | + | * Now open your web browser on your PC and enter the web-interface URL in the address line and you will be greeted with the **First steps** screen that provides a direct link to the online manual.\\ \\ All further steps are explained in in the Initial Commissioning chapter of the operating manual under [[http://docs.kuehlingkuehling.de/reprap-industrial/operating-manual#initial-commissioning]].\\ \\ If you encounter problems with accessing the 3D Printer (or anything else) you may find help in the Troubleshooting section of the online manual\\ ([[http://docs.kuehlingkuehling.de/reprap-industrial-v1/troubleshooting]]). |
| </WRAP> | </WRAP> | ||
reprap-industrial-v1/quick-start-guide.1454935919.txt.gz · Last modified: 2016/02/08 12:51 by Markus Bürgener
Except where otherwise noted, content on this wiki is licensed under the following license: Creative Commons Attribution-ShareAlike 4.0 International License
